TYTILIDIE
METH HEAD
Hey everyone. Since the wife's Ty's trans took a dump and I transplanted my fresh fully built 700 in to hers, I have been giving very serious thought to going with the 4l80. Since I still have a lot of work to do on my Ty, I figure it is just sitting there anyway and may be a good time for this.
I have come up with three ways I can do this but am really not sure which one is the best way.
OPTION 1- Run whatever ECM comes out with the junkyard tranny. I would have to severely modify the harness which doesn't bother me, find a bin for the new ecm and tune it separately. This would be by far the cheapest route. I would pay about $3,500 total but would be a ton of work. Good thing is that if the ECM were to go bad I can run to Autozone and get a new one for $75
OPTION 2-Do everything the same only use the TCi controller. This would cost me approximately $4,000 to do. My problem with that set up is that I don't know what I would do if the controller took a dump on me. I would be pissed!!!
Option 3-Run BS3, XFi, etc. Problem here is that it would cost me about $6,000.00 to do everything and I would have it all done in one shot tuning wise. Again failure of the controller scares me here. What kind of warranty do you get with these things? Is it really worth $2,800??
I think that at this point my build can justify option 3 but just costs a bunch. For you guys that have done any of these, please chime in and give your experience or opinion. TIA.
I have come up with three ways I can do this but am really not sure which one is the best way.
OPTION 1- Run whatever ECM comes out with the junkyard tranny. I would have to severely modify the harness which doesn't bother me, find a bin for the new ecm and tune it separately. This would be by far the cheapest route. I would pay about $3,500 total but would be a ton of work. Good thing is that if the ECM were to go bad I can run to Autozone and get a new one for $75
OPTION 2-Do everything the same only use the TCi controller. This would cost me approximately $4,000 to do. My problem with that set up is that I don't know what I would do if the controller took a dump on me. I would be pissed!!!
Option 3-Run BS3, XFi, etc. Problem here is that it would cost me about $6,000.00 to do everything and I would have it all done in one shot tuning wise. Again failure of the controller scares me here. What kind of warranty do you get with these things? Is it really worth $2,800??
I think that at this point my build can justify option 3 but just costs a bunch. For you guys that have done any of these, please chime in and give your experience or opinion. TIA.