I am really getting sick of this. I lose com at WOT or close enough to it to be in boost.
* Exhibit A*
I've fought with my truck (#769) over it for years. Added mutiple extra grounds and a capacitor to the ignition power wire that feeds the coil. That seemed to help the disconnect but I still get errors. As a note when I connect the MSD 6 I get errors at idle and cruise which tells me ignition noise is behind this. As I get into bost ignition is strained therefore more noise, or leakage??? :?
I've changed laptops to a brand new one that has a serial port. Still no change. Also it links right up so I don't think that the ALDL timing is a issue. If this was a NA vehicle I doubt I would have issues.
*Exhibit B*
Last night Don and I took out Sy112 for a test and anything above 10psi I would get ton of errors and then a disconnect. Real PITA to try to diagnose anything with the datalogger losing connect.
*Exhibit C*
Rudy Valdez's Ty 1450. Same kind of problem lately. He FINALLY bought his own laptop and cable. :wink: It is the same brand cable as mine (AMK)
What do these three trucks have in common? MSD 8.5 wires. Conrad cap and stock coil. ECM's in the glovebox. Ultimate on Don's and Rudys and a Hypertech adapter holding my prom.
What do they not have in common?
1.Mine has no IC pump. A alky kit based on the Shurflo pump
2.Don's has a SMC kit which is currently dead so I doubt that is a issue and a Johnson pump running the IC
3.Rudy's has no IC pump or alky and he has a A2A.
So do any of you datalog with no issues such as a high rate of errors and disconnects? Do you use MSD 8.5?
I just have a feeling the MSD wires are too noisy or something is causing a noisy electrical system and causing issues.
That or the cables from AMK are susceptible to noise.
Ideas? Comment? Discussion?
* Exhibit A*
I've fought with my truck (#769) over it for years. Added mutiple extra grounds and a capacitor to the ignition power wire that feeds the coil. That seemed to help the disconnect but I still get errors. As a note when I connect the MSD 6 I get errors at idle and cruise which tells me ignition noise is behind this. As I get into bost ignition is strained therefore more noise, or leakage??? :?
I've changed laptops to a brand new one that has a serial port. Still no change. Also it links right up so I don't think that the ALDL timing is a issue. If this was a NA vehicle I doubt I would have issues.
*Exhibit B*
Last night Don and I took out Sy112 for a test and anything above 10psi I would get ton of errors and then a disconnect. Real PITA to try to diagnose anything with the datalogger losing connect.
*Exhibit C*
Rudy Valdez's Ty 1450. Same kind of problem lately. He FINALLY bought his own laptop and cable. :wink: It is the same brand cable as mine (AMK)
What do these three trucks have in common? MSD 8.5 wires. Conrad cap and stock coil. ECM's in the glovebox. Ultimate on Don's and Rudys and a Hypertech adapter holding my prom.
What do they not have in common?
1.Mine has no IC pump. A alky kit based on the Shurflo pump
2.Don's has a SMC kit which is currently dead so I doubt that is a issue and a Johnson pump running the IC
3.Rudy's has no IC pump or alky and he has a A2A.
So do any of you datalog with no issues such as a high rate of errors and disconnects? Do you use MSD 8.5?
I just have a feeling the MSD wires are too noisy or something is causing a noisy electrical system and causing issues.
That or the cables from AMK are susceptible to noise.
Ideas? Comment? Discussion?