Datamaster experts help!!!

autoaddictions

Active member
Ok ive decided to try to work out some issues with my Sy. I finally got it back from paint shop and took it to the track for some basline runs. Its slow. 14.4@92 was my best pass of 6. I downloaded datamaster from TTS site and can get it to work.
Does anybody know if the Moates Xtream aldl usb adapter works with datamaster or do i need the belkin decribed on the TTS site.

I must use something to datalog i can feel it pulling timing all the way down the track.

I also have scanner pro on my pc but i can only find a 3 bar map file to use with it.
My sy is bone stock so 2 bar will not work.

Any ideas?????
 

Flyin Ryan

hated cuz he drives fords
Re: Datamaster experts help!!!

I have been using the moates extreme aldl usb cable setup with my datamaster fine... it's an older version 3.4.1 but works like butter.. I could take a look at what settings I have set within datamaster and comport later when I get home if you'd like but they tend to vary with make/model of laptop used.
 

turbodig

Active member
Re: Datamaster experts help!!!

Moates = Good.

You'll have better luck with his stuff than pretty much anything you'll find in the wild. His stuff is designed expressly for this purpose.

You can make scannerpro work with 2bar stuff too, just gotta change the MAP and boost formulas.
 

autoaddictions

Active member
Re: Datamaster experts help!!!

Whats the datamaster version your using?

I downloaded 3.5.1 is that right.

Heres a screen shot does it look right?
 
Last edited:

Flyin Ryan

hated cuz he drives fords
Re: Datamaster experts help!!!

It shouldn't matter what version of datamaster your using.. you just have to make sure you select the right port the aldl cable's using within datamaster and adjust the ALDL Link Timing a bit which is located under "Options/Advanced/serial communication timing" My aldl link timing is set to 191 but the dm readme explains you should start from 196 and work your way up or down in small increments until you can connect because it'll be different for each model/make of laptop used. I also have "disable ECM handshake" disabled within the "options/advanced" menu which might be what you need.

ns6yr.gif


11sfk7m.gif
 
Top