Datamaster question about boost target psi

boosteds10

Finally Fixed
Im seeing something funny with my typhoon. When I put the pedal to the floor the boost is quick to rise to 15psi, then drops down to 10psi and slowly climbs and holds at 15. If I gradually inclrease the throttle, the truck will continuously ramp up and hold to 15psi with almost no drop at all.

So I started looking at the datamaster logs and im looking at this value "BoostTgtPSIg" Im assuming this is what the ecu is telling the boost solenoid to make. Well when the WOT run hits 15psi, the boost target psi is still around 9.5. Im gonna guess that this is why I see the boost drop. why is this happening? On the slower increase to WOT the target psi rises almost the same speed as boost pressure and that would explain the second scenario.

I started to get into $59 a little bit, still dont have the cables but im looking at the stock tune from the code $59 forum. I look at the target psi boost table in that and its his peak psi all the way across the board. Is this safe? Will this solve my problem?

Thanks guys and sorry for the novel.
 

boosteds10

Finally Fixed
Re: Datamaster question about boost target psi

anyone?

need clif notes?

**will making boost target psi table 15psi across the board be ok?**
 

turbodig

Active member
Re: Datamaster question about boost target psi

Target PSI depends on what chip you have. Some do set it that low, at lower TPS.

You'll also see this if you have a 3bar chip but don't change DM to display 3 bar values.

Boost target is just what it says... a target. The ECM sends an initial duty cycle to the solenoid, and then adjusts to hit the "target" until it gets there.

In practice, there are much more factors involved in the mechanicals and pneumatics of the system. The ECM might tell it what to do, but the lags and characteristics of the system prevent it from being a straightforward thing.
 

turbodig

Active member
Re: Datamaster question about boost target psi

boosteds10 said:
**will making boost target psi table 15psi across the board be ok?**

I do all of them that way.

You'll need to mess with init duty cycle to get your desired boost as well. Just setting the target alone won't do it.

See the boost tuning sticky above.
 

boosteds10

Finally Fixed
Re: Datamaster question about boost target psi

Alrighty thanks for the reply. I just bought the truck and was told it was stock. Im going to have to take a look and see if its chipped or not.

Thanks
 
Top