TheNeek
this is my serious face
Well the board was down all of yesterday. So I might have done something dumb.
The truck failed it's first shot at AZ emissions. Doubled the allowable limit of HC at idle. It has a dead miss. So it's either compression or ignition. I figure I'll change the plugs even though Branden just did it before he sold me the truck. Start on the driver's side pull the inner fender well. Etc. Etc. Man that plug behind the steering shaft is a BITCH. Plugs look great for having less than 3,000 miles on them. I change them out anyway. I button up the driver's side. Get to the passenger side. #6 plug wire comes apart in my hand. The connection stays on the plug and busts out of the boot. I think these are those "black beauty" wires. They say turbo on them and Branden said ATR or something. "Huh" I think... So I cut the boot open and recrimp it on just to see if the truck will idle better. Slip the sliced boot on the wire and fire it up. Idles great through the cold start and for about 3 or 4 minutes after. I can hear it missing a little, but not half as bad as before. "problem solved". Well I check the boards today after purchasing wires.
I bought MSD wires from summit. Those don't seem to be a good choice for some people. But here is the kicker. The truck now has CR43TS plugs in it. They aren't R's thank god, but not the 42's that I pulled out. Is this a problem?
3 questions as well.
1. What should the truck pull vacuum wise at idle / cruise? I get about 7.5 lbs of vacuum.
2. I get a check engine light at cruise only on the freeway after about 45 minutes of driving. Bad EGR? or is the truck just pissed off I'm putting miles on it?
3. Best intake for the truck if I'm willing to do a battery relocate? The intake is old/cracking etc.
Thanks guys. You'll find out I write novels for posts. I hope some of you enjoy reading.
Nic
The truck failed it's first shot at AZ emissions. Doubled the allowable limit of HC at idle. It has a dead miss. So it's either compression or ignition. I figure I'll change the plugs even though Branden just did it before he sold me the truck. Start on the driver's side pull the inner fender well. Etc. Etc. Man that plug behind the steering shaft is a BITCH. Plugs look great for having less than 3,000 miles on them. I change them out anyway. I button up the driver's side. Get to the passenger side. #6 plug wire comes apart in my hand. The connection stays on the plug and busts out of the boot. I think these are those "black beauty" wires. They say turbo on them and Branden said ATR or something. "Huh" I think... So I cut the boot open and recrimp it on just to see if the truck will idle better. Slip the sliced boot on the wire and fire it up. Idles great through the cold start and for about 3 or 4 minutes after. I can hear it missing a little, but not half as bad as before. "problem solved". Well I check the boards today after purchasing wires.
I bought MSD wires from summit. Those don't seem to be a good choice for some people. But here is the kicker. The truck now has CR43TS plugs in it. They aren't R's thank god, but not the 42's that I pulled out. Is this a problem?
3 questions as well.
1. What should the truck pull vacuum wise at idle / cruise? I get about 7.5 lbs of vacuum.
2. I get a check engine light at cruise only on the freeway after about 45 minutes of driving. Bad EGR? or is the truck just pissed off I'm putting miles on it?
3. Best intake for the truck if I'm willing to do a battery relocate? The intake is old/cracking etc.
Thanks guys. You'll find out I write novels for posts. I hope some of you enjoy reading.
Nic