canadian said:
I know many moons ago Bruce Plecan had set up and ECM test bench (there's probably photos on diy-efi) so he could fiddle around with the in's and out's of ECMs.
I don't suppose anybody has any plans on how to set one up for our ECM's? I would like to play around with the input/output/logging of an ECM, but don't want to sit in the garage with the truck running for hours on end... mainly because that means I'd have to get the truck running.
Anybody have any ideas?
I've got one set up on my desk... only about 4 wires on it are connected.
All you need to to to make it run (and connect to a scan tool) is hook
up power, ground, ign power, and the data lines from the scan tool.
The pinout is all in the Sy/Ty suppliment... basically, just connect the
sensors you want to the appropriate ECM pins. The diagrams in the
individual trouble code pages help a lot for this.
Much of Bruce's setup for the C3 vintage ECM still applies to our ECM...
the pinout just changes.
Really, all you need to have for good basic functionality is:
555 timer set up to run RPM
555 timer set up to run MPH ( just use a dual timer for both)
Hook up a real tps to the right pins
Hook up a MAP to the right pins (and have a mityvac to pump it up)
Rheostat hooked up to the MAT input (and ground)
Rheostat hooked up to the Coolant input (and ground)
You can add injectors, IAC, o2 to this mix, but it doesn't serve much
purpose unless you're investigating these particular subsytems.
As far as a harness, you need not be picky. Find any '730 equipped car,
and you'll find a harness. Late 80s Pontiac 6000s are good targets.
In fact, the whole '730 ECM will work, unless you're wanting to drive a
WG solenoid. It runs $58 Sunbird/Syty code just fine.
I run my setup off a 3 Amp Radio Shack Power Supply. If you want to
power injectors or an IAC or an 02 sensor with that, forget it. You'll
need 20 amps or so to set up full functionality. Bruce has his set up in
his kitchen, running off a car battery, with a charger running on the bat.
Needless to say, it's quite a kitchen.
Later,
Dig