Aeroking
e.i.
I am re-arranging my gauges, and want to add a GN knock gauge for visual.
I've been running my FAST without a knock sensor. I left the stock Syty one in the block, and this weekend wired it to a TBI ESC module. I'm not getting a knock signal to the ECU. ????
I powered it from a switch 12V source. I remember reading that the knock gauge needs to be powered from a switched 12V that goes off while cranking. I'm wondering if the ESC module needs a similar power source. I have good power, ground, and signal at the module. I'm wondering if 12V power while cranking the engine is buzzing the module.
any ideas?
I've been running my FAST without a knock sensor. I left the stock Syty one in the block, and this weekend wired it to a TBI ESC module. I'm not getting a knock signal to the ECU. ????
I powered it from a switch 12V source. I remember reading that the knock gauge needs to be powered from a switched 12V that goes off while cranking. I'm wondering if the ESC module needs a similar power source. I have good power, ground, and signal at the module. I'm wondering if 12V power while cranking the engine is buzzing the module.
any ideas?