Expert opinions on Datamaster Run needed

powercat6

Active member
Well made my second successful scan tonight and actually figured out how to save it this time. I didn't see any glaring problems, but hey what do I know. Truck is stock but has Walbro 255, hotwired IC pump, electric fan, and AFPR. Fuel tank has a mixture of 93 octane leftover from the trip from New York and 91 octane I bought locally. 93 isn't available around here, the highest I can get is 92 from BP stations.

Thanks in advance.

http://www.fileden.com/files/2009/10/26/2622160/micha.uni
 

turbodig

Active member
Re: Expert opinions on Datamaster Run needed

There's no WOT runs in there, so it's kinda hard to tell anything.

Your intercooler system isn't working very well, if at all.

Did you replace the fuel filter when you did the pump?

Was the brown timing wire pulled when this log was taken? It's throwing a code 42. (EST)
 

powercat6

Active member
Re: Expert opinions on Datamaster Run needed

There's no WOT runs in there, so it's kinda hard to tell anything.

Your intercooler system isn't working very well, if at all.

Did you replace the fuel filter when you did the pump?

Was the brown timing wire pulled when this log was taken? It's throwing a code 42. (EST)

Brown timing wire was connected during the run. I'll have to check on the fuel filter. I didn't do any wide open runs because I wanted to make sure the IC and other auxiliaries were working before I hammered on it. Thanks for the help.
 

powercat6

Active member
Re: Expert opinions on Datamaster Run needed

I took a look under the car and the fuel filter doesn't look dirty so I'm guessing its newer I need to ask my repair shop if they replaced it when they replaced the tank and lines last week. The IC pump runs when I turn the key and the coolant moved in the reservoir. There were some small bubbles on top of the fluid so there must be air in the system. The coolant did not look dirty or gelled up.
 
Top