carVSsuv
New member
got my first ty last weekend and had to get it register which meant the inspection line.
I figured that it would pass because it had a tune up a within the last 2 years in which the truck has only been driven roughly 4000 miles.
Things i noticed was when the truck goes to closed loop the idle gets rough. The tach jumps around a lot and feels like there is a miss in the system. When you accelerate very slowly, you can feel the miss upto 1200-1400 rpms and then it either smooths out or disapears. Truck does seem to run pretty good while driving, but this is my first 4.3 chevy and TY. The temp guage doesnt really go above the first line above 100, so i dont know if that is normal or what. The cat is installed and is followed by a 3 inch ATR.
I have searched and came up with a bunch of ideas that people try to get through emissions, but just wanted to see if there is any updated ways of doing things..
IDLE HC was 832 need 220 pass
2500 RPM HC was 432 need 220 pass
IDLE CO was 1.25 need 1.20 to pass
2500 RPM CO was 1.41 need 1.20 to pass
Test was done with a full tank of 93. I did not run the crap out of it before i got it tested
I plan on doing a tune up since the truck did not get a lot of miles on it during the last 2 years.
Plugs, wires, cap, rotor
I have a FP regulator and will try to install that and lower the FP
Will a half tank of gas and a gallon of denature Alky help?
195 thermostate if its not already one
disconnect the IC pump
any addition suggestions or tricks to get this thing through emissions?
I figured that it would pass because it had a tune up a within the last 2 years in which the truck has only been driven roughly 4000 miles.
Things i noticed was when the truck goes to closed loop the idle gets rough. The tach jumps around a lot and feels like there is a miss in the system. When you accelerate very slowly, you can feel the miss upto 1200-1400 rpms and then it either smooths out or disapears. Truck does seem to run pretty good while driving, but this is my first 4.3 chevy and TY. The temp guage doesnt really go above the first line above 100, so i dont know if that is normal or what. The cat is installed and is followed by a 3 inch ATR.
I have searched and came up with a bunch of ideas that people try to get through emissions, but just wanted to see if there is any updated ways of doing things..
IDLE HC was 832 need 220 pass
2500 RPM HC was 432 need 220 pass
IDLE CO was 1.25 need 1.20 to pass
2500 RPM CO was 1.41 need 1.20 to pass
Test was done with a full tank of 93. I did not run the crap out of it before i got it tested
I plan on doing a tune up since the truck did not get a lot of miles on it during the last 2 years.
Plugs, wires, cap, rotor
I have a FP regulator and will try to install that and lower the FP
Will a half tank of gas and a gallon of denature Alky help?
195 thermostate if its not already one
disconnect the IC pump
any addition suggestions or tricks to get this thing through emissions?