Re: false knock?
Well I changed all ignition parts new ngk UR5 gapped .028, brass cap+rotor, new plug wires, timing set and it seems like I have more KR than before like 2-6 degrees. I don't have DM so I'm using my scanmaster 3 . The only other thing thats different from before is that I had used built 700r4 installed with a 9/11 2800 stall and a racetronix pump relay to go with the 255 walbro that was already on the truck. Heres a little info on my truck - stock chip, 255 walbro, AFPR, Jabsico IC pump hot-wired with rubber heater hose rerouted thru pass.fender, RPM 3" catback exhaust and still running cat. I have been doing pulls with iat's between 85-105 degrees with 13-15 # boost according to my autometer gauge which also what my scan tool is showing. Also my fuel pressure is raising 1# per # of boost with my base fuel pressure set at 43#'s. I don't have a wideband yet. At WOT my o2 mv are at 950. I have checked for loose exhaust parts, checked dp to make sure it was secure and not hitting anything, checked trans lines and fuel lines. Everything seemed to be ok, the fuel lines are still secured by the brackets that bolt them up over the tranny. They don't seem to be loose, but when they go over the bell housing I lose track of them. So today I tried some 100 oct, tank had about 5-6 gallons of 93 still so I added 7.5 gallons of 100 oct. Well no luck the KR is still there and seems to be the same as before. I did look at my motor mounts, the driver side one looks all dry rotted and shot. I then brake boosted the truck with the hood open and the motor is moving a lot , like drivers side moves up 2-3". Would the motor mounts be my problem? Even if that was my problem how would it keep a consistent KR reading, I can see when it first moves but will it move back and forth? When your ac hoses rub thru the hood liner is that also a sign of bad motor mounts? This truck is driving me crazy, I just want it to run knock free. At this point I don't know what else to look for, maybe I'm just over looking something? Please if anybody has any ideas please throw them at me or if anybody who lives close is willing to help that would be cool!