Okay... every once in a while my Ty will have a very rough idle at start, but it always corrects itself within a few seconds and I'm happily motoring away.
This morning, it didn't correct itself, and so I turned it off (rather than watch it struggle), and unfortunately I haven't been able to get it started since.
It tries to idle at ~550 rpm and stumbles and then dies within 3-5 seconds. Sometimes it won't even last 1 second. Leaving the trucklet alone for 10 minutes it'll at least go back to starting for a few seconds.
All gauges look fine, though the volts gauge is a little on the low side since it's not idling high enough. Giving it gas just kills it.
Is this something common I just haven't experienced yet, or is something actually wrong here? Any quick fixes? I'm considering yanking the ECM fuse for 30 seconds to see if that clears it up.
Thanks!
Clint
This morning, it didn't correct itself, and so I turned it off (rather than watch it struggle), and unfortunately I haven't been able to get it started since.
It tries to idle at ~550 rpm and stumbles and then dies within 3-5 seconds. Sometimes it won't even last 1 second. Leaving the trucklet alone for 10 minutes it'll at least go back to starting for a few seconds.
All gauges look fine, though the volts gauge is a little on the low side since it's not idling high enough. Giving it gas just kills it.
Is this something common I just haven't experienced yet, or is something actually wrong here? Any quick fixes? I'm considering yanking the ECM fuse for 30 seconds to see if that clears it up.
Thanks!
Clint