gross polluter!!!!!

chelo

filthy sy
I finally took the dreaded calif smog. After doing the tune-up with all the recommended syty parts and even using denatured alcohol, it still failed. Mostly on idle. 2500 rpm was just slight over the maximum allowed. I even lowered the fp down to 30. It has 50lb injectors, ultimate. How do I lower my hydrocarbons? I have a new cat but have yet to install it.
 

QUICK STORM

B.A.M.F. BMW Tech
Re: gross polluter!!!!!

what plugs do you have on it. i wouldn't run the fuel pressure that low cause then you could get a lean miss. what were your readings?
 

JSM

Active member
Re: gross polluter!!!!!

Cut back the timing as much as possible.

I built a custom chip for local guy that had 0 timing, 0 desired boost (although actuator let it boost some), and idled in the 30mV range, cruised around 150mV.

Was only used to go to emissions and driven carefully. It worked though.
 

chelo

filthy sy
Re: gross polluter!!!!!

The plugs are ngk ur5. new cap, rotor,wires 02 sensor. I think it's my cat that is damaged. It doesnt seem to have a low misfire. the truck actually running real good that way and certainly more fuel efficent. I will change the cat in the next couple of days. If i disconnet the tan wire, wouln't it throw a fault code on the smog station's computer?
 

TheNeek

this is my serious face
Re: gross polluter!!!!!

chelo said:
The plugs are ngk ur5. new cap, rotor,wires 02 sensor. I think it's my cat that is damaged. It doesnt seem to have a low misfire. the truck actually running real good that way and certainly more fuel efficent. I will change the cat in the next couple of days. If i disconnet the tan wire, wouln't it throw a fault code on the smog station's computer?

They shouldn't plug it in. Atleast they don't in Arizona. Isn't this thing OBD1 anyway?
 

JSM

Active member
Re: gross polluter!!!!!

It throws a code, someplaces watch for that others don't
 

QUICK STORM

B.A.M.F. BMW Tech
Re: gross polluter!!!!!

it might throw on the check engine light. but they don't hook it up to the computer its mostly visual.
 

SY2455

70's Veteran
Re: gross polluter!!!!!

Up here in Riverside they will get you on the visual, as it part of the inspection to check the light.
 

chelo

filthy sy
Re: gross polluter!!!!!

Well it's about time. The sy finally passed smog. I tried everything and it still could not pass with the ultimate and 50lb injectors. I decided to go back to stock injectors and stock chip. It passed with a 0.00 CO and with HC measuring at 11- Very clean. The smog guy was just checking everything. He actually checked it over 3 times. This was the longest smog check i have ever had. I'm thinking the culprit of my not passing smog before could be the injectors. Could be there getting stuck? I'll have them checked before throwing them on again.
 

E-Rue

New member
Re: gross polluter!!!!!

on an almost empty tank, add ethanol, or use several small bottles of the emissions pass formula available at most autoparts stores.

e
 

turbodig

Active member
Re: gross polluter!!!!!

chelo said:
Well it's about time. The sy finally passed smog. I tried everything and it still could not pass with the ultimate and 50lb injectors. I decided to go back to stock injectors and stock chip. It passed with a 0.00 CO and with HC measuring at 11- Very clean. The smog guy was just checking everything. He actually checked it over 3 times. This was the longest smog check i have ever had. I'm thinking the culprit of my not passing smog before could be the injectors. Could be there getting stuck? I'll have them checked before throwing them on again.


What's the cali HC threshold? We got a 50#er in the 100-200HC range. Could have maybe
done a bit better, didn't target the particular truck very closely.

There's a *lot* of 50# chips out there running open loop all the time. Unless you have a particularly lean Open loop cal, there'd be no way you'd ever pass.

My .02.
 

chelo

filthy sy
Re: gross polluter!!!!!

Max Hc allowed at idle is 120. Max Hc allowed at 2500 rpm is 180. I used the gauranteed pass smog stuff and denatured alcohol and it couldn't pass. Switch back to the stock stuff and it was very clean. It idles terrible with my cam but hey. So if i switch back to the ultimate chip, will it ruin my new catalytic convertor? I tested the vehicle in valet mode prior to switching back to stock. Is there a chip that runs closed loop? Dig, E ? Either that or I will need a test pipe.
 

mrweelr

New member
Re: gross polluter!!!!!

The Phil Long 50# chip idles at 13.2-13.3 AFR. I'm wondering if this will foul the new 3" cat on my truck over an extended period? I know with the stock chip, it idles at 14.6-14.7 AFR, albeit not as smooth as Phil's chip does. I swapped my stock chip and injectors back in for the Cali SMOG check as well. It barely passed on the CO% at 2500RPM (.88/1.00), everything else was well within limits after we turned the fuel pressure way down.
 

EcSy#2671

Si vis pacem, para bellum
Re: gross polluter!!!!!

What cam are you running?? I'm also a cal guy and just wondering what i need to pass smog.
 
Top