Hi fellow SyTy'ers. I've owned a Syclone for about 5 years now and came across syty.net a couple of years ago, but have been a "lurker" on and off since then. My truck is stock with the exception of an ATR catback system, Pitbull chip, and a Johnson intercooler pump (hot wired) and currently has ~45,000 miles on the original engine. It get's stored in the barn during the winters and driven when the weather gets nice.
Last weekend, I took it out of it's winter slumber in the barn for a liesurely drive around in hopes that spring will get here soon. After charging the battery the truck took a number of cranks to start, but finally did, and ran really well. Took it to town and put a splash of fresh fuel in it and drove around for a bit. Just before I got home, I leaned into the throttle a bit (not quite to the floor) and the engine sputtered a little bit and then died. Both the Check Engine and Check Gauges lights went on at the same time. Keyed off and tried restarting but to no avail. It would crank but never fire. After pulling it home, I jumped the A and B pins on the ALDL to check for codes, but only got "12" to show up (blink 12 three times, then would continue to blink 12). Is it supposed to constantly blink "12" if there are no codes? I'm not sure where to start on this one. It seems to be getting fuel as the fuel "rail" had fuel in it, though I don't have a fuel pressure gauge right now to check fuel pressure. Not sure if it matters, but plugs are NGK UR5, wires are Taylors, cap and rotor are Conrad, and ignition module was replaced a couple of years ago. The engine has always run very well for me with the exception of a rough idle that was cured with a tune up.
Any ideas where to start or what to look for? Any help is greatly appreciated.
Thanks!
Paul
Last weekend, I took it out of it's winter slumber in the barn for a liesurely drive around in hopes that spring will get here soon. After charging the battery the truck took a number of cranks to start, but finally did, and ran really well. Took it to town and put a splash of fresh fuel in it and drove around for a bit. Just before I got home, I leaned into the throttle a bit (not quite to the floor) and the engine sputtered a little bit and then died. Both the Check Engine and Check Gauges lights went on at the same time. Keyed off and tried restarting but to no avail. It would crank but never fire. After pulling it home, I jumped the A and B pins on the ALDL to check for codes, but only got "12" to show up (blink 12 three times, then would continue to blink 12). Is it supposed to constantly blink "12" if there are no codes? I'm not sure where to start on this one. It seems to be getting fuel as the fuel "rail" had fuel in it, though I don't have a fuel pressure gauge right now to check fuel pressure. Not sure if it matters, but plugs are NGK UR5, wires are Taylors, cap and rotor are Conrad, and ignition module was replaced a couple of years ago. The engine has always run very well for me with the exception of a rough idle that was cured with a tune up.
Any ideas where to start or what to look for? Any help is greatly appreciated.
Thanks!
Paul