Ignition module - how hard to replace?

mrweelr

New member
I want to replace my ignition module since it's about the only thing left that I haven't done to my Sy's ignition system. Isn't that part located inside of the distributor? Bitch to replace or no biggie? Lastly, what's the part number so I can just order one from http://gmpartsdirect.com?

Thanks,
Jeremy
 

Daron

Active member
Easy swap. If you can remove your cap and rotor, you can do your module.
Pull the cap and rotor then you will find a plastic device that has two obvious connectors with wires running off towards the firewall. Remove the connectors, remove the two bolts holding the module and swing it towards the passengers side. Then the 3rd connector will become apparent. Undo it and you are home free. Now, carefully clean the surface that the old module was mounted to, then apply the heat conducting creme (that will come with your new module) to the bottom of your new module and then reverse the above to secure the new one in place.

_________________
Daron
1992 Typhoon Blue/Gray
1991 Syclone Best 1/4 12.42 @ 106.1
Member Of Freakin' Ohio (MOFO) SyTy
Daronsy_2.gif


<font size=-1>[ This Message was edited by: Daron on 2002-03-18 23:14 ]</font>
 

mrweelr

New member
Daron, thanks for the awesome tutorial! I'm going to replace the module and possibly my knock sensor while I'm back there. Still trying to get the KR down and the volts up on my Sy. It's running real strong but I know it could be even better.
 
Top