Initial Startup Issues (Surging)

sy1907

SYCOTIC
Guys, I just recently (and finally:tup: ) finished my build and fired it up. I'm running code59 and for those of you familiar with it, I'm using Dig's 60# base bin to get started. I'm very concerned because everyone who has used it so far has had great luck. Well, with me the truck will begin to surge after idling for a minute or so and then die. The afr's are jumping from about 13.1 to 16.8 during this. It doesn't sound like any vacuum leaks develop, fueling is there , spark seems to be good though i haven't tested the coil, wires ohm out, plugs gapped to .035 breakin period, map seems to be reading accurate......I'm just confused. I am not running the stock O2, instead my WB (innovative) but i don't think this matters with the Dig bin. Please correct me if i'm wrong. Has anyone experienced this and if so, what was wrong? Or, if anyone has a bin that works fairly well for them i could give that a shot too. Any advice is welcome, even the "it's about time comment":rant:
 

turbodig

Active member
Re: Initial Startup Issues (Surging)

sy1907 said:
Guys, I just recently (and finally:tup: ) finished my build and fired it up. I'm running code59 and for those of you familiar with it, I'm using Dig's 60# base bin to get started. I'm very concerned because everyone who has used it so far has had great luck. Well, with me the truck will begin to surge after idling for a minute or so and then die. The afr's are jumping from about 13.1 to 16.8 during this. It doesn't sound like any vacuum leaks develop, fueling is there , spark seems to be good though i haven't tested the coil, wires ohm out, plugs gapped to .035 breakin period, map seems to be reading accurate......I'm just confused. I am not running the stock O2, instead my WB (innovative) but i don't think this matters with the Dig bin. Please correct me if i'm wrong. Has anyone experienced this and if so, what was wrong? Or, if anyone has a bin that works fairly well for them i could give that a shot too. Any advice is welcome, even the "it's about time comment":rant:


See the $59 forum.
 

nallj92

Active member
Re: Initial Startup Issues (Surging)

um, its about time, and
you should use that 50lb bin, or hell just load bretts 58 bin on it, it should run fine with that too.

goodluck
 

sy1907

SYCOTIC
Re: Initial Startup Issues (Surging)

I think tonight i will try the $58 unless something else pops up. I just can't figure out for the life on me why it will not run after a minute....and yes Dig, i am trying to read as much as possible on the $59 forum. I think i'm just a little tarded in the head.....:rotf:
 

WyoSyclone

Active member
Re: Initial Startup Issues (Surging)

sy1907 said:
....and yes Dig, i am trying to read as much as possible on the $59 forum. I think i'm just a little tarded in the head.....:rotf:

Hey Dan,
If you start a new thread over on the $59 forum some of us can answer what has happened to us in a similar situation... ...just nice to keep all of that valuable troubleshooting info there :D
 
Top