Knock detection for c-com users

I know this has been talked about before but have never found any answers.I have a Fast c-com computer that doesn't have any way of controlling knock.I will be pulling the motor out soon(rings are bad)and when it goes back in I would like to be able to stand on it but before i do, would like to know if this new motor is knocking.Can something be made with the existing knock sensor? I don't trust afr's to determine knock. Any help would be great.
 

turbodig

Active member
Re: Knock detection for c-com users

I know this has been talked about before but have never found any answers.I have a Fast c-com computer that doesn't have any way of controlling knock.I will be pulling the motor out soon(rings are bad)and when it goes back in I would like to be able to stand on it but before i do, would like to know if this new motor is knocking.Can something be made with the existing knock sensor? I don't trust afr's to determine knock. Any help would be great.

There's always the J&S units... They'll do KR independent of your ECM type.
 

turbodig

Active member
Re: Knock detection for c-com users

I've been a bit curious about KMon as well.

The J&S unit does individual cylinder retard, which makes it kinda useful as a diagnostic aid- points you to the "bad" cylinder, if one is knocking more than others.
 

Big Mike

New member
Re: Knock detection for c-com users

There is also turboxs knock lite:http://www.turboxs.com/more_info.php?ID=212
343.jpg


Deanzsyclone did a review: http://www.syty.net/forums/showthread.php?t=52930&highlight=turboxs
 
Re: Knock detection for c-com users

Thank you guys for your input. I looked at J&S's website.Nice piece, but sounds pricy, I like how it controls each cylinder but wasn't sure if it tells you which cylinder its retarding.Big Mike , thanks for the link, That was a good write up, seems like I have to do some more research on whats all out there.Almost ready to jerk the motor out so I have some time to pick the right one
 
Top