i cannot see a picture.
Updated DM image after tuneup
new....
Wires = 8mm Taylor
plugs = ur5
cap rotor = MSD copper
Ignition = MSD
-
-
![]()
It's usually been idling .700's and it does bounce slightly up and down. I did think the air charger felt it was running hot lately, think my pump is bad? It's hot wired currently
Also see the difference in my knock before tuneup? Seem normal?
Can't tell anything from the knock value from a screen shot.... would need the DM file to see any trends. If your knock count is bouncing around quite a bit at an idle you would want to check to see if the downpipe is hitting up against something, check to see if the fuel lines are banging against the firewall, and see if the motor is rocking around or not (bad motor mounts). The counts will climb when you first start it, then should stop counting up at an idle. Spark retard is the first thing you want to watch while driving.
When the motor cools down take the cap off of the upper IC, start the truck and see if you can see fluid circulating. If not, it could be a bad pump or an air pocket in one of the lines. Use the search button and you'll find lots of threads/remedies.
IC pump relay might be toast.. Might want to try swapping that with the AC relay on the firewall for the hell of it before dealing with yanking the pump.
IC pump relay might be toast.. Might want to try swapping that with the AC relay on the firewall for the hell of it before dealing with yanking the pump.
I believe a dying pump would pull more amps because of the higher resistance... and damn totally forgot about that fuse behind the alt, it's been years since i've had the stock setup.
read that the fuse blows before the pump dies, why is this? and what could cause the fuse to blow in the first place? ( and it was blown before the tuneup )
If the pump shaft gets corroded (bad shaft seal), or if the pump gets clogged up with sediment it will cause a drag on the pump, the pump pulls more current, the fuse heats up then blows. Putting in a bigger fuse just lets the wiring get hotter and creates the possibility of a fire.
I'd pull the lower cooler down (pretty easy), pull the pump off, drain and flush the whole system, etc. You'll sleep better knowing everything is right with it![]()
yea so i replaced the fuse went to work today and the fuse popped again, but before hand i took the ic cap off and saw it had good flow i guess it will always look good even with some small restriction, so i guess i will take the advice and pull it off and flush, i searched but didnt find any write up but its not brain surgery just wanted to see what to expect etc..
It's pretty easy to do. One thing that works really good on the inside of the IC and lower cooler is that CLR (calcium/lime/rust) remover that you buy at the store. Just follow the directions for mixing it and let it soak in there for a few hours.. you won't believe the crud that comes out! Use new rubber heater hose lines, a new pump, and you'll be in good shape.
ok cool, recommend a pump? see vsrious posts etc
Probably just search the threads to see what looks best to you... quite a few threads have pics.... Johnson and ShurFlo are two that come to mind.