Turbo6
10.20@131.8
I thought I would experiment with the MSD so I could get more consistant launches and not have to watch the boost gauge while staged. I installed an MSD 6AL with the 2step module and timing retard box. I put a button on the steering wheel so I could turn off the low RPM limiter and timing retard (if needed) at the launch. My tq converter stall is about 3400-3500 so I put in a 3200 module to start with. It made 12psi at 3200. 16psi with 10 deg retard and 22 psi (the setting on the boost controller) with 20 deg retard and no the truck did not creep foreward because the rev limiter was helping load the motor alot instead of depending on the tq converter to do it all. Stuck in the 3000 rpm module and got 14psi with 10deg retard. I really dont plan on ever retarding the truck 20 deg retarded at the line but it was an experiment. 10deg retard is very safe and still get 16psi at 3200. The benefits of this should be that it that its easier on the trans and you can launch the same every time. If it spins you can just lower the retard or turn it off. If it still spins you can lower the RPM of the 2step. The only launch I have tried was on the street at 3200 rpm and 10deg retard and the truck was spinning and got sideways. It may hold a launch like that at a good track. I think Waller uses a setup similar to this.