I just datalogged my truck during a 0-80 WOT pull. I'm asking for some help in what to look for in the DM during WOT runs? Like Lterm, Sterm, BPW, InjDC, VE or anything else? I been having stumble problems from a slow takeoff at a light or simular, only on very little part throttle. I been playing with my fp and it's now 60psi base, the stumble is much better. Hardly anything but it think i could raise the fp some more. I'm trying to figure out with DM if i'm running rich, lean or perfect. I'm planning of going to a 1/8 track this week but would like to know what to look for in DM when i'm there. I can't send the DM file tonight but i could send it tomorrow morning when i get to work (left internet cable at work). This is the mods i have:
> >Ultimate set on T1-20, but boost not controlled by ECU
> >Speed Pro I-2441 pistons 030
> >3-angle valve seat with back cut valves
> >Polished lower and upper intake runners
> >Everything is port match to gaskets
> >KB Air cleaner
> >Stock turbo and down pipe
> >High flow 2.5" cat 3" mandrel bent exhaust after cat no muffler
> >Adjust fpr set @ 60psi now, and yes it raises with boost (have fp gauge)
> >255 lph HP Walbro pump
> >All new sensors except IAT and knock
> >Clevite 77 bearings (Nascar)
> >NGK Iridium plugs
> >Taylor "409" wires
> >MSD dist
> >15psi wg actuator, no boost control (straight from comp housing to wg)
> >EGR blocked between lower and upper intake
> >Stock injectors (cleaned and flow tested)
> >SAAB 9000 FMIC
> >160 t-stat, stock clutch fan
I'm pulling a max of 6.9* timing and knock count went from 1751 on 0mph to 2695 at 89mph after that i let of the throttle. It started to pull timing at 3925rpm/24mph/1st gear---1.8* to 3600rpm/40mph/second gear----4.6* after that i slowly went down to 0* at 3725rpm/70mph/third gear, then it started to climb again until i let off at 3975rpm/89mph/forth gear i think. Spark retard was 6.9*, i have problem getting in forth due to that valve in the trans that dosen't like WOT shift to forth gear.
O2 is between 930-950 the whole WOT run.
If somebody would like to help and need more info feel free to ask, thanks.
> >Ultimate set on T1-20, but boost not controlled by ECU
> >Speed Pro I-2441 pistons 030
> >3-angle valve seat with back cut valves
> >Polished lower and upper intake runners
> >Everything is port match to gaskets
> >KB Air cleaner
> >Stock turbo and down pipe
> >High flow 2.5" cat 3" mandrel bent exhaust after cat no muffler
> >Adjust fpr set @ 60psi now, and yes it raises with boost (have fp gauge)
> >255 lph HP Walbro pump
> >All new sensors except IAT and knock
> >Clevite 77 bearings (Nascar)
> >NGK Iridium plugs
> >Taylor "409" wires
> >MSD dist
> >15psi wg actuator, no boost control (straight from comp housing to wg)
> >EGR blocked between lower and upper intake
> >Stock injectors (cleaned and flow tested)
> >SAAB 9000 FMIC
> >160 t-stat, stock clutch fan
I'm pulling a max of 6.9* timing and knock count went from 1751 on 0mph to 2695 at 89mph after that i let of the throttle. It started to pull timing at 3925rpm/24mph/1st gear---1.8* to 3600rpm/40mph/second gear----4.6* after that i slowly went down to 0* at 3725rpm/70mph/third gear, then it started to climb again until i let off at 3975rpm/89mph/forth gear i think. Spark retard was 6.9*, i have problem getting in forth due to that valve in the trans that dosen't like WOT shift to forth gear.
O2 is between 930-950 the whole WOT run.
If somebody would like to help and need more info feel free to ask, thanks.