Bill Z
Donating Member
My pretty much stock truck with Ultimate chip for stock injectors) starting running poorly. It starts up fine but won’t accelerate quickly. Even in boost, it doesn’t accelerate. However, if I give it throttle very slowly, I can get it up to 65 and 70 MPH. Also, at RPM between 1500 and 2000 it bucks and won’t take any sort of rapped throttle.
I changed the distributor cap and bug, spark plugs and fuel filter with little improvement.
I hooked the truck to DataMaster version 3.4.1 (the default install) and noticed that the ‘Speed’ indicator on Datamaster was all over the place (like teeth on a saw). It is really noticeable when I look at the line graph at the bottom of DataMaster. This was noticed with the ignition on but without the engine running. Of course it wasn’t going anywhere but DataMaster thought it was going 150 MPH then 0 then back up over 100 and again down to 0. The speedometer stayed at 0 the whole time. Didn’t even jump or twitch.
I unplugged the sensor cable from the transmission and still DataMaster thought it was going at a high rate of speed. It would be nice it the truck could actually do stunts like that.
What sensors or signals go together to make DataMaster think it is going at these speeds?
I’m thinking that this is one of my problems with not having acceleration. The computer doesn’t know a reference.
By the way, I get normal voltages at the TPS. From .47V to 4.07 (full throttle). TPS voltage or % doesn’t change when the Speed is jumping all around.
Someone please help.
I changed the distributor cap and bug, spark plugs and fuel filter with little improvement.
I hooked the truck to DataMaster version 3.4.1 (the default install) and noticed that the ‘Speed’ indicator on Datamaster was all over the place (like teeth on a saw). It is really noticeable when I look at the line graph at the bottom of DataMaster. This was noticed with the ignition on but without the engine running. Of course it wasn’t going anywhere but DataMaster thought it was going 150 MPH then 0 then back up over 100 and again down to 0. The speedometer stayed at 0 the whole time. Didn’t even jump or twitch.
I unplugged the sensor cable from the transmission and still DataMaster thought it was going at a high rate of speed. It would be nice it the truck could actually do stunts like that.
What sensors or signals go together to make DataMaster think it is going at these speeds?
I’m thinking that this is one of my problems with not having acceleration. The computer doesn’t know a reference.
By the way, I get normal voltages at the TPS. From .47V to 4.07 (full throttle). TPS voltage or % doesn’t change when the Speed is jumping all around.
Someone please help.