Methuselah said:
This sounds promising. You dont necessarily need to divulge your well-tuned programs, but rather provide a reference implementation of a three bar with the differences pointed out.
If you want to get started in chip programing, you will need to do a lot of research on your own. I would try searching the DYI-ECM, the tuning section of this board and F-body 3rd gen board. You will need to have a good understanding of how your engine works and how the ECM works in general. I would start off with the base 2 bar system and tune that to get started. You want to take baby steps, try fooling around with some of the parameters in PROM. At least with non-turbo motors, most of the tuning is done at part throttle, you this do first and then you do the WOT tuning.
After you perfect that, you might be able to find the information for a 3 bar converison or someone here might be nice enough to give it to you. Then you can tune your truck with higher boost. Then you can make mutilpe files for different boost levels and then look into making a switch which changes between the programs.
On the bright side is that you will know your truck inside and out, and you can make a program that is better than the Ultimate which is tuned for a broad range of trucks. The bad new is your just looking for a cheap way out in making an ultimate chip, your better off working a 2nd job at minimum wage, it will be cheaper.
BTW BG do you have your own defintion files for 3 bar bins or do you just just modify the tables (load vs VE if I remember right, I am just a beginner with a MAF system) to work with the different readings.