Question for Dig

Quickstop [UK]

Combating adversyty.
Dig,

I read your website detailing how to install the WBO2 and you mentioned connecting the WB signal ground to BB9 on the ECM.

According to the SyTy supplement, that pin is unused. Are all the pins that are unused grounded?

I actually went and connected the signal ground to the black and white wire for the ECM ground...

Just wanted to double check.

TIA,

Mark
 

turbodig

Active member
Re: Question for Dig

Quickstop [UK] said:
Dig,

I read your website detailing how to install the WBO2 and you mentioned connecting the WB signal ground to BB9 on the ECM.

According to the SyTy supplement, that pin is unused. Are all the pins that are unused grounded?

No. In fact, that's one of the few available grounds that isn't populated with a wire.
I think there's one more, although I don't remember the pin # offhand.

I actually went and connected the signal ground to the black and white wire for the ECM ground...

Just wanted to double check.

TIA,

Mark

Any good ECM ground should be fine, I try to avoid the main grounds to keep noise from other devices from boogering up the sensor readings. I've used the case screws as a ground successfully. It just looks cleaner if you wire it in with the proper terminal.

I put a 2-prong weatherpack connector pigtail on all the trucks I work on.... that way I can connect and disconnect the wide-band easily. Works nice.
 

Quickstop [UK]

Combating adversyty.
Re: Question for Dig

I have not yet got a pin for the F14/WBO2 hack - you know the fiddly little peice of metal that goes into the connector, but i will be doing that soon, prob just use a bullet connector so I can remove it easier.

Thanks for your help!

Mark
 

sytyguy

Moderated User
Re: Question for Dig

A connector/wire from an old computer power supply (ATX) fits perfectly. Use a pin extractor to pull the connector out, cut the wire 4-5" back and that'll leave plenty of slack to wire in the WB O2. Snaps right into the GM ECM connector and looks factory. Plus, an ATX PS gives you 8 different color wires to choose from.

Hood
 

turbodig

Active member
Re: Question for Dig

Quickstop [UK] said:

The small power supply connectors, not the ones with the round pins.

Darn near any GM car built between 1988 and 2000 should have these terminals in them.
Junkyard diving for harnesses is usually the quickest.

Your UK GM-equivalants probably have them too. Lotus used GM ECUs, also.
 
Top