WyoSyclone
Active member
Dig has been very cool in helping me, the newb, with some basic questions.
I was planning on doing tuning this weekend but was a little confused by one of Dig's responses (he's hopefully taking some time off and having a nice weekend). Dig told me to warm up my Sy just driving around with my KB chip in. Then he said to quickly switch out the chip I have programmed with the new code59 BIN, and to quickly put in the new 3bar MAP. He said to then start it up (while still warm) and get the baseline AFR readings at idle. He said things would be lean and that I'd have to work at getting things richened up to ~14.7 at idle.
My question: Dig didn't say anything about needing to install the wideband O2. Can I do the above routine he suggested without installing the wideband?? This can probably only be answered by the Code59 gurus since it deals with the voltage tables utilized by the code.
Thanks much!
I was planning on doing tuning this weekend but was a little confused by one of Dig's responses (he's hopefully taking some time off and having a nice weekend). Dig told me to warm up my Sy just driving around with my KB chip in. Then he said to quickly switch out the chip I have programmed with the new code59 BIN, and to quickly put in the new 3bar MAP. He said to then start it up (while still warm) and get the baseline AFR readings at idle. He said things would be lean and that I'd have to work at getting things richened up to ~14.7 at idle.
My question: Dig didn't say anything about needing to install the wideband O2. Can I do the above routine he suggested without installing the wideband?? This can probably only be answered by the Code59 gurus since it deals with the voltage tables utilized by the code.
Thanks much!