92Ty#1524
New member
Ive had issues with the engine either stalling or not wanting to start at all when the engine is up to temp. It usually happens after it has sat for a few minutes (ie, run in and out of a store). Idle is noticeably rougher and slightly lower when it finally starts.
Major mods include 3 BAR map, 50# injectors, Ultimate chip, Crane cam grind HR-194/271-2-12, L35 block and heads (not totally sure about the heads), headers and .030 overbore.
Ive never noticed it before because it hasnt been a daily driver until recently.
Any ideas?
Jack
Major mods include 3 BAR map, 50# injectors, Ultimate chip, Crane cam grind HR-194/271-2-12, L35 block and heads (not totally sure about the heads), headers and .030 overbore.
Ive never noticed it before because it hasnt been a daily driver until recently.
Any ideas?
Jack