mildtowild
Custom Upholsterer
since i relocated my battery to the trunk, i have a occasional problem where it will click but not turn over. gets worse when it is hot. I used 0 gauge wire. I am thinking possibly a bad crimp on the starter?
Here's how I have mine ran.. all with 2 gauge cable/stock alt for two years no problems but eventually went with a 140 amp alt because of voltage spikes by my efan.
Also all ground wires are also 2 gauge and I forgot to put in the picture that I still have the stock ground strap on the driver side head to firewall as well.
![]()
This is where my issue was too. My wire from the alt was too small. Bumped it up to a 4gauge and BAM, 14.4 at the battery! I've been chasing that issue for a while now and it made a huge difference as stated above. I still get the occasional starter click as you mentioned, but it got ALOT better.:2cents:But since you loose the bat + wire to the alt I also had a new one of those made that goes from the alt to the bat connection at the starter. Interestingly my DataMaster shows a noticeably higher and more even voltage during WOT that previous runs with the original bat setup.:2cents:
Have you ever tried to see if the kill switch will work if the engine is already running?
Unless you have removed the original alternator wiring I think it will continue to run.
Although I didn't test this I was told by an alt shop that this was true. Also, and more important, do not just switch the alt output wire. If you do and you switch off the truck using the cutoff you will get a voltage spike (+30 volts) in the alt which will kill it. You must switch the alt field wire.
Hmmm, this might be a good idea actually. As long as the wires that feed the truck from the alt are fed from the "switched" side of the switch and not the alt. This could be done with a wire from the starter without having to go all the way to the switch. The wire from the alt to the bat side of the switch would have to be of sufficient gauge to prevent voltage drop to the switch at the rear (per NHRA). Did I miss something??