Threw a code 44 after engine cleaning

Nick NY

New member
bdubb said:
bust a vacuum line going to the FPR?
I dont think so but I will start there. The truck was not throwing any codes until after I sprayed the motor down with Gunk.
 

spooldup

Super Member
code 44,


Check the ECM wiring connections, particularly terminals 8 and 15. Check for vacuum leakage at the TBI base gasket, vacuum hoses or the intake manifold gasket. Replace the oxygen sensor.


I would have to think vaccum like dubb said. Either do the bike tube trick or spray carb cleaner and listen for it. Did you scrub the motor? Maybe you knocked a hose off? Hows the idle? If you want nick i can come by and run dm on it to see if the o2's lazy.
 

Nick NY

New member
It idles and runs fine. I didnt scrub anything so I dont think I knocked off a line plus all my Vac lines are brand new, every one. Morgan said the Gunk may have fucked up my O2. Tomorrow I will check the lines and then go from there. I should be getting my DM soon so I will be able to make a few runs. Like I said the only thing i did today was spray some Gunk on the motor and hose it off. Other than that nothing has been touched and it was running fine with no codes up until after i cleaned the motor.
 

kwick6

Donating Member
I've knocked a vac line off the map cleaning the engine compartment.

It ran w/o it hooked up for quite awhile, and didn't throw any codes.

I'd look over your vac lines, its so easy to knock one loose while your in there moving stuff around.
 

Nick NY

New member
UPDATE:
I cleared the code this morning before work, let the truck warm up and drove all over the place and didnt throw anything, maybe it was false? I dont think anything was stored as I had the batery disconnected when I did the IC pump and havent gotten a light since then. I will still go throught he lines although all my vac lines are new. Could some of the Gunk just have gotten in the connector for the O2 and now just dried up over night?
 
Top