Jim........I always had good luck with the distributor wrench put out by Performance Tool. They're a cheaper tool line and the bends in the wrench are a little sloppy which happens to work out better in this case (since the better lines seems to hit on the rail, etc....).
Nonetheless, I took an stud (intake one IIRC) and had an extra nut welded on the very top. This allows you to turn the stud via the top nut and the bottom (original) nut locks the distributor clamp down. With the added height, I can get to the top nut with a standard 9/16 open end wrench.
FWIW, your base timing will be 0 regardless of the chip (Vortec, L35, stock, etc....).
HTHs
Hood