TP issues and variable boost control

Osmosis

New member
I 've got two issues going on with my TY.

First, I changed out my boost valve to the stock boost controller. I was only getting 12 psi of boost when I had the desired boost set to 16psi. I messed with the duty cycle tables (2 of them) and set them from around 30-39 to 80 across the board. I seem to get close to 16psi, but when I"m WOT, boost seems to fall back to 12.5-14ish.

I did a few data runs and I noticed my Tuner Pro is not seeing my boost now? WTF?

Any help would be greatly appricated!:tup:
 

WyoSyclone

Active member
Re: TP issues and variable boost control

I 've got two issues going on with my TY.

First, I changed out my boost valve to the stock boost controller. I was only getting 12 psi of boost when I had the desired boost set to 16psi. I messed with the duty cycle tables (2 of them) and set them from around 30-39 to 80 across the board. I seem to get close to 16psi, but when I"m WOT, boost seems to fall back to 12.5-14ish.

I did a few data runs and I noticed my Tuner Pro is not seeing my boost now? WTF?

Any help would be greatly appricated!:tup:

Have you checked first to make sure you don't have a problem with the wastegate actuator (pin hole leak)? Also, did you set the initial wastegate rod adjustment?

I believe that if the WG rod is adjusted correctly, and if you have the WGDC and boost dialed back to zero, that you'll get approximately 11lbs of boost at WOT. You may try that and see what you get.
 

Osmosis

New member
Re: TP issues and variable boost control

TY Rob! I have the wg rod set to 7/8 covering the hole as directed in the service manual, so I know that's right. When I had the two tables for duty cycle, it' seemed like I was getting 11-12 psi of boost and that was all I could pull out of the tune and turbo. I adjusted the duty cycle to 80.00 and I was getting kind of close to what I was asking. It was kind of hunting for 16psi but mainly hovering around 14psi. Kind of frustrating getting my desired boost pressure.

Also, WTH????/ TP not reading my boost pressure while using the stock boost controller. It read my boost psi with the boost valve? I wonder if there is a correlation here? Done for the night, got a few cold ones on board and looking for answers.

Just went out to the garage, waste gate acuator holds pressure just fine.


Thanks for the iders and help, Keep EM comming:tup:
 
Last edited:
Top