TurboJunk
questionable
Well i just installed an ultimate today and it idles fine (vacumm is low but anyway).
While driving the car sputters BAD, won't go over 1900 rpm's. And if I sit there and power break the truck to put it under a load it does the same thing.
I checked it numerous times its seated properly, tryed 2 different 3bar sensors (one new one used), theres no wires rubbing or exposed, tryed it in all the settings, i have a SnapOn scanner hooked up and my TPS is working correctly. ***AND I SEARCHED THE FORUM*** BoostedSUV had the same problem but there was no answer.
The truck runs fine with the stock chip back in so i know my moduels good and all my ignition stuff.
i got this chip like 4th hand so i dont the history.
If anyone has any ideas please Reply
CHARLIE
While driving the car sputters BAD, won't go over 1900 rpm's. And if I sit there and power break the truck to put it under a load it does the same thing.
I checked it numerous times its seated properly, tryed 2 different 3bar sensors (one new one used), theres no wires rubbing or exposed, tryed it in all the settings, i have a SnapOn scanner hooked up and my TPS is working correctly. ***AND I SEARCHED THE FORUM*** BoostedSUV had the same problem but there was no answer.
The truck runs fine with the stock chip back in so i know my moduels good and all my ignition stuff.
i got this chip like 4th hand so i dont the history.
If anyone has any ideas please Reply
CHARLIE