fabricator
2280
i 'm trying to find vavle covers for my sy. chrome or polished .but nun have the holes for two pvc vavles on pass. side any input would be great stock 4.3
valve covers
- Thread starter fabricator
- Start date
Flyin Ryan
hated cuz he drives fords
Re: valve covers
might want to try pming this guy.... his sheet metal covers look pretty sweet
http://www.syty.net/forums/showthread.php?t=38389&page=7&pp=15
fabricator said:
might want to try pming this guy.... his sheet metal covers look pretty sweet
http://www.syty.net/forums/showthread.php?t=38389&page=7&pp=15
fabricator
2280
Re: valve covers
what are you wanting for them
what are you wanting for them
SY-1193
Active member
Re: valve covers
Just read your post. The stock set up (2 PCV's) uses only one hole in the valve cover and a "T" tube with 90 degree rubber hose ends that the PCV's press into at each end. One goes to the rear side of the throttle body the other enters before the turbo air intake into the crossover tube.
So there is only one hole in the valve cover on passenger side.
fabricator said:
Just read your post. The stock set up (2 PCV's) uses only one hole in the valve cover and a "T" tube with 90 degree rubber hose ends that the PCV's press into at each end. One goes to the rear side of the throttle body the other enters before the turbo air intake into the crossover tube.
So there is only one hole in the valve cover on passenger side.
fabricator
2280
Re: valve covers
thanks for the info. i remember putting two new pvcs in and asumed i put them in the valve cover. i will go out and pull the blanket off and take a closer look. thanks again :tup:
thanks for the info. i remember putting two new pvcs in and asumed i put them in the valve cover. i will go out and pull the blanket off and take a closer look. thanks again :tup:
fabricator
2280
Re: valve covers
sold will a check or money order work.
sold will a check or money order work.