Re: Will a defective intercooler throw a code? ---
alwayscode390 said:
...if my intercooler is bad or just my pump or both ...
The pump is the only thing that can really go bad. Our IC system is basically 2 radiators, an electric water pump and hose. You could have a dead pump, a good pump that is not getting power, a kink in you hose, no water, or a leak in the system. Those are the only problems I can think of. You can’t really troubleshoot it if it is not hotwired because you won’t know if the pump is running (with the engine running you can’t hear it) or even if it should be. When hotwired, it will run with key in the “on” position even when the truck is not running. So, hotwire it, turn the key to on without starting the engine, go to the front of the truck and if you can’t hear it then it is not running. Use a test light to see if it is getting power. If not, check the fuse, if it is good replace the relay on the firewall (take the part # off of the top of it because the dealer will not now what you are talking about) it costs about $10. If the pump is getting power but doesn’t run, get a new pump from APE. If you have to replace the pump, replace the lines with heater hose, a little clear hose will help with getting the air out.
If I had it to do again I would make sure the pump is pulling water out of the bottom port in the upper IC and pushing into the cche. Mine is pulling from the cche and pushing into the upper IC, making it extremely difficult to get the air out because you can not remove the cap while the pump is running or water will run out like a freaking water hose. I never got to see what a stock pump flows like, as mine was dead when I bought the truck, but the APE pumps work very well.