will not start

[PJ2397SY]

just reassembled after intake gaskets and just turns over.

check guages light flashing
check eng lite on
45psi in fuel rail
spark off of coil

any sugg?

 

[BigBadSmoosh]

Re: will not start

its just cranking?
did you hook up the fuel rails right? is the injector harness connected?
any spark at the plugs?

 

[tealty]

Re: will not start

Did you only rip off the upper and lower? I'd check to see if plugs are wet, which will mean the injectors are opening. Then check timing....prolly off 180*? Pull the code by jumpering a and b terminal on the aldl with a paperclip.
yeah with the check engine light, this now has me thinking its electrical (duh). I'd check all electrical connections that you played with. Injector connectors, dist, and main connector that connects the inj harness to the main harness.
later
Jordan

 

[PJ2397SY]

Re: will not start

Injector harness was disconnecting
Reconnected harness
Engine turns over now then abruptly stops. Engine cranks over 10 times then stops
Code 12 is flashing

 

[Jimmy]

Re: will not start

Check the ECM B fuse

 

[PJ2397SY]

Re: will not start

ecm fuses are ok
plug wires are correct
truck is now turning over but not steady
kinda like hiccuping
dist is in and my marks line up and rotor lined up w/marks i made prior to removal

 

[bezerk]

Re: will not start

ecm fuses are ok
plug wires are correct
truck is now turning over but not steady
kinda like hiccuping
dist is in and my marks line up and rotor lined up w/marks i made prior to removal

there are 2 timing marks on the stock balancer..


take off the cap, let the rotor point to #1 cil..

you could be 180 of, than change the wires 180* and try again..

 

[PJ2397SY]

Re: will not start

1 tooth off
all set just finished washing it(1230am)
thanks to all
pj

 

[Captain Morgan]

Re: will not start

stupid toofs :haha: