It's actually kind of funky how it does it....
The ECM is fast enough to see the voltage rise as you turn the key on to apply ignition power.
When it sees this, it considers it a "key-on" event, and reads baro.
The problem with this, is that during cranking, if your battery is a bit weak or your connections dirty, voltage can drop down into that "key on" range. This causes another BARO read, this time while the engine is cranking and there's a bit of vacuum there. Voila, funky BARO reading.
I've been working on fixes to try to insure that BARO read happens only when the key is on, but the engine isn't turning. It sounds simple enough, but due to the timing at which the BARO routine runs, it's tough to tell sometimes.
Turning the key and holding it will get you a good read, but it may get "re-read" by another voltage event.
That's the Wheaties-Whizzer, right there.