sy#2921
BAMF
Here is the deal took the truck for the first test failed the HC 470ppm allowed 220ppm. CO was .4% allowed 1.2% but isnt counted against me
Proceeded to change the following:
cap and rotor (msd)
coil (msd blaster)
ignition module
plugs (for emissions only but cr43ts)
o2 sensor (delco)
checked wires and all tested at ~60 ohms
checked timing and was set to zero
fuel pressure set at 46psi without vacuum connected
put a 195 stat in it instead of 160
fuel filter
put one bottle of heet in the tank to like 8 gallons
retested it off the record and failed again 350ppm CO is now down to .1%
my thoughts were that i could do the easy trick of lowering the FP with the AFPR but i want to see if i cant correct whats going on.
Any suggestions???
quick storm wanna chime in?
Proceeded to change the following:
cap and rotor (msd)
coil (msd blaster)
ignition module
plugs (for emissions only but cr43ts)
o2 sensor (delco)
checked wires and all tested at ~60 ohms
checked timing and was set to zero
fuel pressure set at 46psi without vacuum connected
put a 195 stat in it instead of 160
fuel filter
put one bottle of heet in the tank to like 8 gallons
retested it off the record and failed again 350ppm CO is now down to .1%
my thoughts were that i could do the easy trick of lowering the FP with the AFPR but i want to see if i cant correct whats going on.
Any suggestions???
quick storm wanna chime in?
Last edited: