sly dvl
Ya, it's got a Turbo
Ok, so after some searching and taking some readings I've concluded that I have a 3 BAR MAP on my Sy. I was concerned because scan-tool readings were only showing a max. pressure of about 8-9 PSI when my boost gauge was showing 14 PSI. However, that concern is now resolved now that I know I have a 3 BAR.
My question is though, on the top of ANY MAP Sensor there are a few pinholes that expose the top of the sensor to the atmosphere, since it's a comparative sensor. While the vehicle is running, if I apply a vacuum to these pinholes, should I not expect to see a change in the MAP readings? I think I should, since removing the atmospheric pressure from the top of the sensor would change its reference point, and change it readings.
I'm not really looking to solve a problem, I just stumbled across this thought while doing some tuning/testing.
My question is though, on the top of ANY MAP Sensor there are a few pinholes that expose the top of the sensor to the atmosphere, since it's a comparative sensor. While the vehicle is running, if I apply a vacuum to these pinholes, should I not expect to see a change in the MAP readings? I think I should, since removing the atmospheric pressure from the top of the sensor would change its reference point, and change it readings.
I'm not really looking to solve a problem, I just stumbled across this thought while doing some tuning/testing.