Flyn Sy
Damn Qwik Old Guy
I've got a '93 Ty that I can't get a 3-BAR to run in, no way, no how. It has minimal mods, e.g Manual Boost Controller and JET stage 2 chip, and that's it.
Here are the symptoms that I'm experiencing with the 3-BAR installed:
1. Idles like crap when it's cold (RPM all over the map)
2. Stalls when you put it in gear
3. Idles ok when warm, although RPM is a little low (about 600)
4. When driving above 50 MPH, throws code 44 (lean exhaust), and then shuts down momentarily.
Actions I've taken to get this booger to work:
Took the 3-BAR out of my Sy and put it in the Ty.....no luck. I put the 3-BAR out of the Ty and put it into the Sy....works fine. Took the JET chip out of the Ty and ran the 3-BAR with the stock setup.....still runs like crap. Put a 2-BAR into the Ty and ran it with both the stock chip, and then the JET chip installed.......the world was a happy place.
Don't know where to go from here. Any help would be appreciated.
Here are the symptoms that I'm experiencing with the 3-BAR installed:
1. Idles like crap when it's cold (RPM all over the map)
2. Stalls when you put it in gear
3. Idles ok when warm, although RPM is a little low (about 600)
4. When driving above 50 MPH, throws code 44 (lean exhaust), and then shuts down momentarily.
Actions I've taken to get this booger to work:
Took the 3-BAR out of my Sy and put it in the Ty.....no luck. I put the 3-BAR out of the Ty and put it into the Sy....works fine. Took the JET chip out of the Ty and ran the 3-BAR with the stock setup.....still runs like crap. Put a 2-BAR into the Ty and ran it with both the stock chip, and then the JET chip installed.......the world was a happy place.
Don't know where to go from here. Any help would be appreciated.