autoaddictions
Active member
I might have a option to buy a bare bowtie block brand new in the crate for 2500.00 its bin in storage for 5 years. Is this a fair deal. What you guys think.
I know its a wet sump!! Not sure on the #s. Ill have to check that and get back to you.SY-1193 said:GM Part #????
(located on the back side of casting by #6 cyl.)
it may also have a number ground into the front slightly left side above the timing cover look there also. GM casted later versions from oldter castings so the number on the back is the original casting but they did updates to the block like better main caps etc. and there will be a number in a ground off square block stamped # into the block on the front.
Is it wet sump? - You kinda need that or the machining cost to convert it is costly.
Price is good if it is a #10134388,#10185051, #22534333 all cast, wet sump.
NOJIMMY said:John, while were on the subject of V6 bowtie blocks, is there conflicting info about the nickel and tin content on some of the bowtie blocks?
True or False:
Tin and nickel are two metals that are commonly alloyed with cast iron to improve durability, hardness and heat dissipation. Some production engine blocks have the numbers "010", "020" or both cast into their front face, just above the main bearing bore. (The timing cover must be removed for these numbers to be visible.) If both numbers are present, one about the other, some say it indicates that the block alloy contains 10% tin and 20% nickel. A single number, either a "010" or "020" represents the amount of nickel and indicates negligible amounts of tin. No numbers, other than the casting numbers that are typically found beneath the timing cover, translates to only minor amounts of tin and nickel being present in the block alloy. (Note: Mortec says "1% and 2%" however)
True or False:
A high nickel block is desirable because the tin helps the melting metal flow in the casting to forge a better, tougher block (with the nickel making it harder vs stronger).
True or False
On the 010-020 blocks their suppose have better main webbing compared to the 010 blocks. And on some of the 010-020 blocks look for 2482 on the center caps as those are the GM performance caps.
Lastly (as an important distinction) Nickel may make it harder, but not necessarily stronger. Its much like the debate between hypereutictic and forged pistons. If I'm building a high-rpm screamer, some will chose a softer block because it can absorb more impact than a harder/more brittle block. Completing the analogy by comparing this to pistons, forged pistons are stronger, but softer. They will deform and absorb more shock before failure. Cast or hyp pistons actually have a higher yield strength than forged, but when they go, they GO... like shatter.
Its kinda like glass. Really hard, but if you put just a little deformation pressure on it you can break it very easily. I've seen improperly treated cryo'd/nitrated cranks fail
because of harmonics and the brittleness of badly treated casted cranks.
thanks
-Larry
James Thomas said:Wow Larry, mind telling us how / where we can find this type of info? Inquiring minds need to know! Great post and good info man :tup:
_________
James