I dont get it! :banghead:

I have been having this over boost or cut out problem since June. I don’t really even know what to make of it now. I don’t have a boost gauge yet but this is what I can tell you guys. When I’m at WOT the engine cuts out around 80 - 100 mph. The engine light comes on momentarily and then goes away. If I’m correct this is know as over boost. My truck is all stock except new intercooler water lines, a new IC pump and a cone filter. To try and stop the over boost I adjusted the wastegate rod all the way out until I ran out of thread and the rod came disconnected. I hooked the rod back up so it just stayed on. I then did another run. Again cut out. I even found some 114 octane gas and ran some of that in there to make sure I was not getting knock in case the engine was shutting down because of that. Well to me it’s clear I have no boost control no matter what I do. Does this mean I am forced to get a different turbo that has an effective waste or get an external waste gate? I read as much as I could on this site about it. It just seems to me that every one else just adjusts the waste gate or they don’t have a stock down pipe. Some one even suggested I may have a wrong chip? I guess I really don’t know much about that. I was going to get a 3 bar map, fuel pump, FPR and an ultimate. But you guys stress getting it running right before modifying. Any thoughts…?
 
Last edited:

jjorgensen52

NHSTE - I'm the only one!
Re: I dont get it! :banghead:

If you do have a chip I would check that... otherwise, check out you wastegate / boost control solenoid. The stock turbos had decent boost control so I would check that to see if anything associated with the wastegate is squirrely.
 

SY2932

Administrator
Re: I dont get it! :banghead:

jjorgensen52 said:
If you do have a chip I would check that... otherwise, check out you wastegate / boost control solenoid. The stock turbos had decent boost control so I would check that to see if anything associated with the wastegate is squirrely.

DITTO. My truck was overboosting like crazy when I first bought it. Then one day on a whim, I dropped the ECM and saw that the tape was cut... Found a "Hypercrap" chip in there
icon_frown.gif
. Replaced it and that eliminated the problem.
 

JustBeachin

Plays well with others
Re: I dont get it! :banghead:

hmmmmm.....between 80-100 mph. It doesn't sound like overboost to me, it sounds like you're starving for fuel, especially since you said it's pretty much stock.
The first thing I'd do is get diacom, datamaster, or something like that to pull the codes. Lacking that, I'd learn how to do it by jumping the aldl pins. But if I'd hafta guess with the limited info you've given, I'd still say fuel.

Given that, I'd replace the fuel pump, and fuel filter for starters. That fixed my top-end fall flat on it's face that was affecting me at the strip way back when.

DO NOT TRY ADDING AFTERMARKET PARTS (DIFFERENT TURBO, ETC) to try and fix your problem.

Get it running right first with what you've got.

Datamaster > new turbo
 

nallj92

Active member
Re: I dont get it! :banghead:

if you want to drive up north i might be able to help check it out next week
 
Re: I dont get it!

Re: I dont get it!

nallj92 said:
if you want to drive up north i might be able to help check it out next week


Awh thanks for the offer. I have put the Sy away for the year. I was just looking for ideas for in the spring. We should get in touch though.
 
Last edited:

nallj92

Active member
Re: I dont get it! :banghead:

once spring comes around we can throw a wideband on it and do some DM logging to check everything out
 

live1053rulz

Nor Cal SyTy
Re: I dont get it! :banghead:

Haha, banghead?

I found a Hypercrap chip in mine too. Be sure that's not holding you back.
 
Re: I dont get it! :banghead:

Well about 6 months later and I have finally taken care of all my problem. I got the ultimate in. afpr and 3 bar. I have no more over boost problems with the 3 bar and the ultimate chip controls boost really well. I get a flicker of the knock light every now and then. Is that pretty normal. Its not going crazy but just a flicker in between shift. It does the same thing on all settings T115 - T118. Also I get bad knock after I let off the gas after WOT. What is that all about? I have base fuel pressure set at 50psi. Input please :)
 

jjorgensen52

NHSTE - I'm the only one!
Re: I dont get it! :banghead:

Rookie said:
Well about 6 months later and I have finally taken care of all my problem. I got the ultimate in. afpr and 3 bar. I have no more over boost problems with the 3 bar and the ultimate chip controls boost really well. I get a flicker of the knock light every now and then. Is that pretty normal. Its not going crazy but just a flicker in between shift. It does the same thing on all settings T115 - T118. Also I get bad knock after I let off the gas after WOT. What is that all about? I have base fuel pressure set at 50psi. Input please :)
The knock after a drop at WOT is because there is still pressurized fuel in the intake track which will enter the cylinders and detonate because of the high heat. Should only be a few seconds maximum.
 
Re: I dont get it! :banghead:

jjorgensen52 said:
The knock after a drop at WOT is because there is still pressurized fuel in the intake track which will enter the cylinders and detonate because of the high heat. Should only be a few seconds maximum.

OK that makes sense. Any other tuning tips I should try besides methanol injection?
 
Last edited:

jjorgensen52

NHSTE - I'm the only one!
Re: I dont get it! :banghead:

Rookie said:
OK that makes sense. Any other tuning tips I should try besides methanol injection?
The next logical question is what data equipment do you have? Datamaster, wideband, etc?
 

turbodig

Active member
Re: I dont get it! :banghead:

jjorgensen52 said:
The knock after a drop at WOT is because there is still pressurized fuel in the intake track which will enter the cylinders and detonate because of the high heat. Should only be a few seconds maximum.

Uhm, no.

Decel enleanment happens at throttle off... the fuel gets shut off entirely.

Severe knock on a throttle off (when there should be no boost pressure whatsoever) is usually due to a noise issue, or a horribly bad tune. It would knock before that, if the tune were a problem.

Post your DM file someplace.. I'll take a look.
 
Re: I dont get it! :banghead:

well I figured it out. I had my base fuel pressure way way to high. I backed it down to 50. I was still getting knock. I tried 2 jugs of octane booster with half a tank of gas and im running t118 on the ultimate with virtually no knock at all. I was surprise to see the octane booster help out so much. I just figured it was a gimick.
 
Top