The Devils Own Chariot
Active member
I have been having this over boost or cut out problem since June. I don’t really even know what to make of it now. I don’t have a boost gauge yet but this is what I can tell you guys. When I’m at WOT the engine cuts out around 80 - 100 mph. The engine light comes on momentarily and then goes away. If I’m correct this is know as over boost. My truck is all stock except new intercooler water lines, a new IC pump and a cone filter. To try and stop the over boost I adjusted the wastegate rod all the way out until I ran out of thread and the rod came disconnected. I hooked the rod back up so it just stayed on. I then did another run. Again cut out. I even found some 114 octane gas and ran some of that in there to make sure I was not getting knock in case the engine was shutting down because of that. Well to me it’s clear I have no boost control no matter what I do. Does this mean I am forced to get a different turbo that has an effective waste or get an external waste gate? I read as much as I could on this site about it. It just seems to me that every one else just adjusts the waste gate or they don’t have a stock down pipe. Some one even suggested I may have a wrong chip? I guess I really don’t know much about that. I was going to get a 3 bar map, fuel pump, FPR and an ultimate. But you guys stress getting it running right before modifying. Any thoughts…?
Last edited: