Ok so I have made some discoveries. After I corrected the vacuum lines the truck has been running alot better. Not perfect but definitely better. I would drive it, them come to a stop. I felt no slight bump, hiccup, stutter, nothing. I go into the auto parts store to pick up some connectors for the tan wire under the dash, and when I get back in the truck and start it, it's running like trash again. Wtf. I get home, shut it off for a few min, get back in, start it, and it's running good again. So I shut it off again and restarted it, running like crap. Shut off, start, running good. So the truck changes the way it's running whenever I restart it. I've also got the code 42, and now a code 45 stored in the computer. Code 45 is O2 sensor detecting the truck running rich.
Gotta love these trucks! :tup:
Gotta love these trucks! :tup:
:rotf: serioulsly..I hate my trucks but I love the F#%# out of them. Just like women, they drive me nuts but I love them:lol:
Following this thread, curious to see what the ruling will be. Good luck!
What Damian mentioned about the wiggle in the tan wire worked for me on a 92' S10Blazer I had. Fixed the code 42 problem. I was really hoping it would have fixed it for you.
Well a rebuilt dist sure wouldn't hurt. The way you describe your starting, good once, bad the next, it might be worth a try. Why 2 wheel drive? What's going on there?
It'll be a blast once you get it going. Not really sure how bad your misfire is but I always see post on here (and also from my own experience) that these trucks from factory never really idled right. They do have a small hick up in the idle. My buddy use to have a Sy and it drove him nuts:lol:My Sy is pretty much stock. When I put the chip, it did change a bit..but not much. Not saying there's nothing wrong with your truck, just saying that the misfire could be smaller than expected. Really hope you solve this mystery.:tup: it'll be a shame not nt be able to drive it at its full potential.
Ok so I have made some discoveries. After I corrected the vacuum lines the truck has been running alot better. Not perfect but definitely better. I would drive it, them come to a stop. I felt no slight bump, hiccup, stutter, nothing. I go into the auto parts store to pick up some connectors for the tan wire under the dash, and when I get back in the truck and start it, it's running like trash again. Wtf. I get home, shut it off for a few min, get back in, start it, and it's running good again. So I shut it off again and restarted it, running like crap. Shut off, start, running good. So the truck changes the way it's running whenever I restart it. I've also got the code 42, and now a code 45 stored in the computer. Code 45 is O2 sensor detecting the truck running rich.
I love following a thread where the OP tries stuff and perseveres. You're a dying breed - keep it up and you'll be a happy man!!!
This could be a MAP sensor going bad...
Have you tried the other notch on the balancer?