Re: Tuners please help
Drove the truck a little today. No lean spots. Rob didn't tell me the adjustments he made to the bin. I could tell he smoothed the cells out. I'm sure he will post and let us know.
I ran autotune after one log and its trying to put the valley back in again. So I smoothed it out again. Is there a time were you stop using autotune and just manually adjust the cells?
Just did one log. The fuse blew again on my new Flex-A-Lite fan. Something is going on there. But I am going to make another post about that.
One common thing I see here, is that the people struggling are looking for AFRs to be some number.
We beat this to death, I know, but give the motor what it wants- don't pay so much attention to what the AFR numbers are in the transitional cells. Closed loop trim brings the AFR into line over longer periods, which is what's really affecting fuel consumption.
Phil, I think you're past the autotune point... it's a good thing to get you started, but it, too, is too fixated on AFR numbers. Do some basic pull-aways, and watch where the bubble goes. Bump fuel up just past the point where the stumble goes away. You'll start to see common threads if you watch the bubble long enough.
There really needs to be a "lesser PE" that handles the tip-in cases. In pure theory, this shouldn't be necessary, but the quirks in the fuel algorithm cause some things to happen that wouldn't if we had a truly accurate Speed-Density equation. The PE that we have isn't much- I can understand where Peter is coming from with the PE disable.
I suspect what Rob did was bump the 50-60-70 kpa cells up in off-idle RPMs.
A good exercise to learn what the system is doing- Have somebody else drive, and watch the bubble. Don't change anything, just watch where the bubble goes in the VE table as the driver does pull-aways, passes, roll-ups to stop. You'll see places where AFR goes wacky-lean, despite the fact that those cells are pretty close in steady-state operation.