bezerk said:will wait on the price you give me for the pulley.
Than i probberbly gonna do, what is should do.......
Alright?
bezerk said:What do you mean by hot-tanking the block??
bezerk said:Anny thoughts about the oil-cooler?
And throw me in an Auto meter Phantom gauge 2 5/8" oil-pressuere Mechanical <= Goood?? or electrical is better easier to wire??
??????????????Sigo said:bump
nightdiver said:??????????????Sigo said:bump
bezerk said:don''t know who is taking care for the balancing, polishing of the crank.
But they need the harmonic damper right?
how is that going to be?
IMO if you are going to spend the money for a 4 bolt conversion then it would be best to pay a little extra for the splayed versions. Non splayed are easier for a machinist to install but the piece of mind would warrant the extra cost IMO to step up to the splayed mains.so with the 4bolt maincaps (should it be save with normal 4bolt, or do i get splayed?)
i need line bore, so wich seize of bearings do i get?
with the camshaft bearings, just install them, or should they be installed and than be reseized to the specifications of the cam?
sytyguy said:Anytime you change pistons, rods, etc....you need to have the rotating assembly rebalanced. If you were just re-ringing the engine, then you could slap it back together w/o rebalancing and be fine, but not in this case (I wouldn't chance it). They will need your balancer and flywheel to balance the rotating assembly.
When the machinist line bores the main caps, you'll wanna run whatever main bearings the crank is cut for. Same for rod bearings.
Cam bearings are one size (usually) and are not sized per camshaft.
HTHs and Myclone........correct me if I'm wrong on anything.![]()
Hood
bezerk said:Ryan told me that somebody is willing to trade me a crankshaft so that the work is done in the US, i will sent my old one back.
So maybe that person also could trade his damper, that would be great.