Search results

I have an "Open Box" kit, Baer Pro + 14" Model 4301256B (black calipers). These are the 6-piston caliper BIG Brakes. Box is open but, Kit is complete - even has the Baer Brake Lines. Summit online price is $2494.95 (+ tax). $2000.00, shipped Lower 48. I do have a Syclone but, it's not put...

Sorry, I'm bored. Been reading recent posts about low Oil Pressure and Knocking Noises. My "fresh" engine had a very subtle knock at just off idle, under load. Here's what I found when I opened up my knocking engine: All 6 top rings were either split, broken or collapsed This piston has...

I've got RPM's A2A and am looking for advice on an air cleaner setup. I'm running a PTE51, with a 3" inlet. This turbo is a little larger than stack, so it extends further forward (closer to the core support). Thus my piping is a little different from standard (Turbo Outlet only). Before I...

OK, I've searched and cannot find a picture of how this damn thing is installed. I have 2" lowing blocks and can't seem to get it lined up anywhere. Please, NO thread references - I've checked those and if there were any pictures, they are long gone. If someone has a genuine picture (side...

I'm looking for some direction... This week I am picking up front (upper control arm, calipers and rotors) and rear (calipers, backing plate/mounting block & rotors) LS1 F-body brakes from a local wrecking yard. I am running 17" ZR1 clones. I am probably going to keep ABS. My issue is that I...

Where do you "clock" the 45 degree fittings for braided steel 6AN trans cooling lines. My engine is out, with the trans is sitting a little low and I can't visualize what looks like a good position for the lines that will route forward to a front mounted cooler. Thanks, Chris

Anyone out there know Bill Duke in Saginaw, TX? I was referred to him by Speedtek Performance in Ft. Worth. Bill told me that he just finished a Sy for a local fellow - if you're out there, please contact me via PM or @ 214-762-2910. I understand that your setup is similar to mine. Thanks, Chris

Need a part number for the Temp (?) Sensor located on driver's side head, below the exhaust port. My plug has a green wire and a silicone seal. Thanks

Well, looks like I now need another block! :rant: # 2 main threaded hole has a crack from the "previous" injury. It is very obvious that engine was severely over-boosted/leaned, resulting in: 1. # 2 & # 3 Mains distorting and spinning inserts, cracking the block...

Tore down the Sy engine today, after progressively louder knocking: Broken 1st rings on 3 & 5. Spun # 3 main bearing - lots of copper showing on the others. So, I guess I'll be safe and try a new crank, line bore splayed caps, zero-gap rings and start from scratch. Any recommendations on...

Just got my Sy from a relative (read all about it in the New Members section). Trying to set it up and I need help with a few things. I have some additional information about the truck since my initial post last week. MIne is Sy #612 with about 32,000 miles. Stock block with polished-journal...

I just bought my cousin's '91 Sy. He had too many projects and was burned out on this one. I've been checking out the Forum for the last week and have found lots of useful information. Here is a rundown on the truck, which I just trailered from Davie,FL to Ft. Worth, TX: #612 - 32,000 miles...